Remove the shaft until you’re done with this step. Once you’re done, take the tool out and confirm the alignment the clutch. Do this by gently reinserting it until you can see the bottom.

Utilizing a jack that has an adjustable plate, set your plate. Make sure that the transmission is on it before it is placed underneath the truck. Make adjustments to the truck according to your liking and adjust the height of the transmission in accordance with the truck’s slope or level.

Move the jack towards your engine. Lift the transmission. Ensure that there is nothing in the chassis that the transmission is in contact with it as it should. Once the shaft is aligned to slide into the clutch spline, make use of a turn tool with a bright light and gradually until the shaft that is the input of the transmission grabs on the clutch splines.

In the rear of the transmission, press on the jack to slip into the early spline by adjusting it as needed. Following that, you can push the transmission itself to slip it through all the splines into the pilot bearing. This completes the installation of the semi-truck’s transmission.

2ibqk8v453.